30mm Hole Carb Spacer & Gasket Kit

To fit most pit bikes with a 30mm opening on the carbs

Porthole diameter - 30mm
Spacer thickness - 5mm
Fitting hole centres - 48mm
Fitting hole diameter - 6mm

Fitment - This item will fit most pit bikes and motorcycles/scooters with a 30mm carburettor, including PZ30, Molkt, Mikuni, and many, many more!

This is a high-quality, carburettor spacer kit and acts as a vital heat shield between the manifold and the carburettor itself by creating an air seal between the carb and the manifold. This helps to ensure your engine runs well without air leaks, which will affect performance.

To fit many pit bikes and dirt bikes ranging from 140cc to 190cc (Including 150cc, 160cc, 170cc, etc) and many more. Chinese, Japanese, Etc.

Easy to install, no instructions needed!

Installation: Fit the fibre gasket between the 30mm plastic spacer (heat-sink) and the intake manifold, aligning the bolt holes. The carburettor then seals to the spacer via its pre-installed O-ring—no extra gasket needed.