Now your ride doesn't have to end when the sun goes down!
Kit comes complete with:
- KTM style headlight (E marked)
- Enduro rear light with number plate mount
- Hydraulic brake pressure switch
- Full complete wiring loom
- Key switch
- Multi-function bar control
- 12v horn
- 12v rectifier
- Indicator relay
- Micro E marked LED Indicators x4
- Rubber headlight mounts
- Full installation instructions
- Suitable for kick start bikes
This motorcycle enduro lighting kit is designed to be a simple way to provide headlight, tail/brake light, indicators and ignition for your motorcycle. The components have universal applications and will work on almost any motorcycle with minor modifications. The kit is intended for motorcycles with existing 12v supply feed from the engine or can be powered from a battery alone.
The motorcycle enduro lighting kit is easy to install and does not require cutting into or messing with your motorcycle’s existing wiring as this is all replaced with a whole new replacement wiring harness.
We make this kit as simple as possible for installation on your bike, with included installation instructions to guide you along the fitment process.
NOTE: To ensure this kit can be used on your bike without modification. Your bike must have the following:
- A 12v supply from your stator - An easy way to check this if you are not sure is by looking for two wires (usually) that are not currently in use from your engine. These are usually in the form of 1 yellow wire and 1 white wire. Or in some cases 2 yellow wires.
- A 5 pin CDI. (unless you run this alongside your existing loom for lights only).
If your bike does not have these as standard then your bike will need a few extra parts to run this kit of which we can provide separately if needed. In most cases this kit will fit straight on or alongside your bikes existing set up.
Please check the specifications above to make sure it fits your bike, motorcycle, dirt bike, ATV or pit bike.
NOTE** The loom supplied with this kit is suitable for electric start bikes and will connect directly to your existing battery.
NOTE* To stabilise your lighting system and prevent flicking from the stators alternating current, we recommend the fitment of a 12v 4ah minimum battery, this will provide a DC output to the headlights smoothing the lighting output.
Q - Will this kit fit my pit bike?
A - Yes this kit will fit all pit bikes. If you have no 12v supply already (spare white/yellow or yellow/yellow wires), you will need to replace your stator for a 12v version, we have these available in our store.
Q - Will this kit fit KTM, CRF or YZF enduro or MX bikes?
A - Yes, although we have never fitted these ourselves we have sold many of these kits to customers who have fitted them to these bikes...... but as most Japanese motocross bikes do not have 5 pin CDI's, its just a case of leaving your existing wiring on your bike to run the engine as normal and running our light kit alongside it separately. Just connect our loom to your bikes two charging/stator wires and this will keep the battery charged and your lights bright.
Q - Can I run this kit on my bike even if I don't have the 2 charging stator wires on my bike?
A - Yes, however you will require a 12v 4ah minimum battery. Remember, batteries do not last forever so you would need to recharge your 12v battery regularly and if used in this way we would recommend using a Lithium or Li-Po type battery for longer life, over using a standard 12v lead acid battery. Upgrading the headlight bulb to an LED variant will also extend battery life somewhat.
Q - Is there a speedometer kit available that will plug into this loom without any wiring modification?
A - Yes , we have available a compact LED speedometer kit that comes with a universal fitting kit, this kit is built specifically for this loom (plug & play) - no wiring experience required. We have these available in our store - simply look for 'speedometer kit'.